LSL MANTIS-RS for Kawasaki Z 1000 14-18, without license plate light

LSL MANTIS-RS license plate holder

Making good bikes perfect. Following this motto, LSL has developed the license plate holder LSL MANTIS-RS.

It fits perfectly to your motorcycle and underlines the lines of your bike with its sporty design.

And as usual from LSL, one has thought of everything.
The model-specific bracket of the LSL MANTIS-RS allows replacement without further drilling or cutting on the vehicle.
The design fits perfectly to the rear of your motorcycle, using the original mounting points of the vehicle.
Against damage to the cables, sharp-edged feedthroughs are protected with rubber membrane grommets.

The license plate is made of 2 mm thick sheet steel, laser-cut, edged and weather-resistant black powder-coated.
The fixing of the license plate in the correct position is done by an additional locking screw.

The LSL MANTIS-RS turn signal brackets, adjustable in width, are suitable for any type of accessory turn signal. This adjustment option allows you to find the right position for your turn signals. The adaptation to the most different EU license plates is therefore no problem. The mounting holes of the turn signals have a diameter of 10 mm and are slotted to the side. This makes it possible to mount the turn signals without disconnecting them from the wiring harness.

Also the slider for the attachment of the rear reflector is individually adjustable. An adaptation to the different designs of the EU license plates is therefore no problem.

The two rubber washers supplied are used for the vibration-reducing screw connection of the license plate. An additional rubber buffer supports the license plate on the underside.

Details:

- model-specific bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- suitable for European number plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy fixing without further work steps (e. g.B. Drilling)
- easy mounting of the license plate through slotted holes

Included in the scope of delivery of the LSL MANTIS-RS are:

- Model-related bracket with mounting parts
- LSL MANTIS-RS license plate retaining plate
- Adjustable turn signal brackets
- E-tested reflector with adjustable bracket
- Mounting instructions

Notes:
- If there are side reflectors fitted to your original number plate holder, these must be refitted in a suitable position or replaced with new ones.
- The special turn signal holder 280-974 is optionally available for the original turn signals.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from LSL, which are available in many different designs, are certainly a good alternative.