LSL Kentekenplaathouder Mantis-RS PRO | Kawasaki Z1000

LSL license plate holder MANTIS-RS PRO with license plate light

Making good bikes perfect. Following this motto LSL has developed the license plate holder MANTIS-RS PRO.

It fits perfectly to your motorcycle and underlines the lines of your bike with its sporty design.

And as usual from LSL, one has thought of everything.
The model-specific bracket of the MANTIS-RS PRO allows replacement without further drilling or cutting on the vehicle.
The design fits perfectly to the rear of your motorcycle, using the original mounting points of the vehicle.
Against damage to the cables, sharp-edged feedthroughs are protected with rubber membrane grommets.

The license plate is made of 2 mm thick sheet steel, laser-cut, edged and weather-resistant black powder-coated.
The fixing of the license plate in the correct position is done by an additional locking screw.

The width-adjustable turn signal brackets of the MANTIS-RS PRO are suitable for any type of accessory turn signal. This adjustment option allows you to find the right position for your turn signals. The adaptation of the accessory turn signals to the most different EU license plates is therefore no problem. The mounting holes of the turn signals have a diameter of 10 mm and are slotted to the side. This makes it possible to mount the turn signals without disconnecting them from the wiring harness.

Also the slider for mounting the reflector is adjustable to your license plate size. An adaptation to the different designs of the EU license plates is therefore no problem.

The two rubber washers supplied are used for the vibration-reducing screw connection of the license plate. An additional rubber buffer supports the license plate on the underside.

Included in this PRO version of the MANTIS-RS is the very small LSL license plate light milled from high quality aluminum with mounting plate and support arm. The bracket is adjustable in height and designed to allow mounting in the legally required position.

Details:

- model-specific bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- suitable for European license plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy fixation without further work steps (eg.e.g. drilling)
- easy mounting of the license plate by slotted holes
- license plate light incl. Holder included
- license plate light, E-approved
- infinitely adjustable license plate light
- many different options for mounting the license plate light

The scope of delivery of the MANTIS-RS PRO includes:

- Model-specific bracket with mounting parts
- MANTIS-RS license plate mounting plate
- Adjustable turn signal brackets
- Reflector with adjustable bracket
- E-approved license plate light
- Mounting instructions

Note:
The special turn signal bracket 280-974 is optionally available for the original turn signals.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from LSL, which are available in many different designs, are certainly a good alternative.